Menu
Your Cart

d&b audiotechnik D40 Amplifier

power amplifiers - technology - sound - d&b audiotechnik D40 Amplifier Power Amplifiers
d&b audiotechnik D40 Amplifier


d&b audiotechnik D40 Mobile specific four channel amplifier.


For more information please open the following link: D40 Technical Data

  • Condition: New
  • Stock: Price on Request
  • Model: N-dbau-d40-0001
  • Location: Bulgaria,Greece
0.00€
Price Ex Vat

power amplifiers

technology

sound

D40 amplifier

This four channel Class D mobile amplifier provides the power density required for high-efficiency d&b systems including the KSL System, V-Series, Y-Series and T-Series.
The D40 incorporates comprehensive loudspeaker management, switchable filtering functions as well as user definable equalization and delay capabilities.
Onboard enhanced energy saving features, power efficiency and Automatic Wake up enable you to save on resources and meet environmental responsibility requirements.
The D40 incorporates up to eight input channels with four analogue inputs and four AES3 channels with corresponding link outputs. Each input channel can be routed to any of the output channels.
The D40 utilizes a switch mode power supply with automatic mains range selection and active Power Factor Correction (PFC) to produce a clean current draw and ensure stable and efficient performance under adverse mains conditions.
Access to the d&b Remote network is via Ethernet using the Open Control Architecture protocol (AES70 / OCA). The D40 is controlled using the integrated web interface, which enables access via a browser, or using the d&b R1 Remote control software.
For applicable d&b loudspeakers, d&b LoadMatch enables the D40 amplifier to preserve tonal balance when cable lengths of up to 70 m (230 ft) are used.

DSP-Digital Signal Processing
Equalizer2 x 16-band - PEQ/notch/shelving/asymmetric
Maximum Output Power
4 Ohms4 x 2400 W
8 Ohms4 x 2000 W
Signal Input and Output Connectors
Analog Inputs3-pin XLR female (A1 - A4)
Analog Link3-pin XLR male (A1 - A4)
Digital Inputs3-pin XLR female, AES3 (D1/2, D3/4)
Digital Link3-pin XLR male (D1/2, D3/4)
Speaker Output Connectors
Linear4 x NL4 / 1 x NL8
Bridged2 x NL4
Network Connectors
ETHERNET2 x RJ 45 (etherCON), ETHERNET 1 (PRI) Remote control via R1, Star topology, ETHERNET 2 (SEC) Currently disabled
Frequency Range
Frequency Range35 Hz – 25 kHz

Write a review

Note: HTML is not translated!
Bad Good